1985 Mercedes 380SE - wont start - Mercedes-Benz Forum
Mercedes-Benz Forum Mercedes-Benz Forum Header Right

Auto Insurance

» Featured Product
Wheel & Tire Center

Go Back   Mercedes-Benz Forum > Mercedes-Benz Enthusiasts Forums > DIY/Tech Help

BenzForum.com is the premier Mercedes-Benz Forum on the internet. Registered Users do not see the above ads.
Reply
 
Thread Tools Display Modes
Old 12-21-2012, 02:15 PM   #1
SummerSouvenir
Junior Member
 
Join Date: Dec 2012
Vehicle: 1985 Mercedes 380se
Location: New Jersey
Posts: 10
1985 Mercedes 380SE - wont start

RE: 1985 Mercedes 380se


I hope someone here can help me out.
A few years back my car wouldnt start, and I knew it was the fuel pump relay,
so I jumpered terminals 7 and 8, the car started right up.
Now, a different but similiar problem, car wont start,
fuel pump not engaging (no sounds). I jumpered terminals 7 and 8,
fuel pump running BUT THIS TIME CAR WILL NOT START.
I bought a new fuel pump relay, no sounds of fuel pump running with this new relay installed.
I only hear the fuel pump when I remove the relay and jumper 7 and 8.
Last time the car started, now it wont start when it is jumpered.
Any suggestions please ???

Thanks,
James
SummerSouvenir is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old 12-21-2012, 07:23 PM   #2
eric242340
Moderator
 
eric242340's Avatar
 
Join Date: Jun 2009
Vehicle: S320 W220/Zotye 1.3
Location: Jiangsu province China
Posts: 1,077
The pump is bad, when you put a jump wire in you send the full power to the pump and force it to rotate, but with a relay in and a high resistance from the pump the relay contacts will be forced to open.
__________________
ERIC
eric242340 is offline   Reply With Quote
Old 12-22-2012, 12:42 AM   #3
SummerSouvenir
Junior Member
 
Join Date: Dec 2012
Vehicle: 1985 Mercedes 380se
Location: New Jersey
Posts: 10
Quote:
Originally Posted by eric242340 View Post
The pump is bad, when you put a jump wire in you send the full power to the pump and force it to rotate, but with a relay in and a high resistance from the pump the relay contacts will be forced to open.
Thanks Eric for your reply,
but what I dont understand is that when the jump the 2 terminals I HEAR the usual buzzing sound of the fuel pump, so I assume it is working.
A few years back as I said, my relay failed, I used a jumper wire, and the car started right up.
This time, I hear the buzzing sound using the jumper wire but no start.
Should I try and pour a little gas thru the throttle body, or use starting fluid to see if it attempts to start ??? Perhaps even the slightest indication that it wants to start would indicate a bad fuel pump ???
Once again, I always thought that the pump is working if I hear that usual buzzing sound ?


Thank You,
James
SummerSouvenir is offline   Reply With Quote
Old 12-22-2012, 01:43 AM   #4
eric242340
Moderator
 
eric242340's Avatar
 
Join Date: Jun 2009
Vehicle: S320 W220/Zotye 1.3
Location: Jiangsu province China
Posts: 1,077
Sure try a starting spray into the valve body to see if it starts, if it does then check the fuel filter to see if it is blocked.
__________________
ERIC
eric242340 is offline   Reply With Quote
Old 12-23-2012, 02:57 PM   #5
SummerSouvenir
Junior Member
 
Join Date: Dec 2012
Vehicle: 1985 Mercedes 380se
Location: New Jersey
Posts: 10
No good with the starter fluid, not even the slightest indication that it wants to start.
Seems to be a no spark situation. Never no recent driveability issues, always started with the first turn of the key.
Other day went from store to store no problems until I left the last store.
Now, just cranking and no firing.
Cap, rotor, wires, coil wire, plugs all good.
Coil tested around 9400 ohms secondary and primary at 0.80 ohms.
I dont have a spare coil to try, I did have a universal coil somewhere but cant find it now.
Guess this leaves ignition control module or distributor pick up (green wire) ?
I think thats all it could be.
Neither of these have ever been replaced.
I do not think that either of these can be tested or bypassed to test but I may be wrong.
Any suggestions please ?
Thanks,

JAMES
SummerSouvenir is offline   Reply With Quote
Old 12-23-2012, 05:39 PM   #6
eric242340
Moderator
 
eric242340's Avatar
 
Join Date: Jun 2009
Vehicle: S320 W220/Zotye 1.3
Location: Jiangsu province China
Posts: 1,077
Unplug the coil lead from the distributor cap and get some one to crank the engine whilst holding the lead close to ground and see if you get a spark.
__________________
ERIC
eric242340 is offline   Reply With Quote
Old 12-24-2012, 01:20 PM   #7
SummerSouvenir
Junior Member
 
Join Date: Dec 2012
Vehicle: 1985 Mercedes 380se
Location: New Jersey
Posts: 10
NO spark, but there is 12V going to coil.
I did as mentioned, check coil with ohmeter, was in specs.
I hope its not the dist. pickup, that looks hard to get to.
Any suggestions please ?

Thank You,
James
SummerSouvenir is offline   Reply With Quote
Old 12-24-2012, 06:00 PM   #8
eric242340
Moderator
 
eric242340's Avatar
 
Join Date: Jun 2009
Vehicle: S320 W220/Zotye 1.3
Location: Jiangsu province China
Posts: 1,077
Quote:
Originally Posted by SummerSouvenir View Post
NO spark, but there is 12V going to coil.
I did as mentioned, check coil with ohmeter, was in specs.
I hope its not the dist. pickup, that looks hard to get to.
Any suggestions please ?

Thank You,
James
12v to coil - no spark - bad coil.
__________________
ERIC
eric242340 is offline   Reply With Quote
Old 12-27-2012, 01:14 PM   #9
SummerSouvenir
Junior Member
 
Join Date: Dec 2012
Vehicle: 1985 Mercedes 380se
Location: New Jersey
Posts: 10
Hi Eric,
I put a different coil in and still not firing.
James
SummerSouvenir is offline   Reply With Quote
Old 12-27-2012, 06:09 PM   #10
eric242340
Moderator
 
eric242340's Avatar
 
Join Date: Jun 2009
Vehicle: S320 W220/Zotye 1.3
Location: Jiangsu province China
Posts: 1,077
Quote:
Originally Posted by SummerSouvenir View Post
Hi Eric,
I put a different coil in and still not firing.
James
Have you checked to see if this coil is giving spark? What is the vehicle identity #?
__________________
ERIC

Last edited by eric242340; 12-27-2012 at 11:44 PM.
eric242340 is offline   Reply With Quote
Sponsored Links
Advertisement
 
Reply

  Mercedes-Benz Forum > Mercedes-Benz Enthusiasts Forums > DIY/Tech Help


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
1985 380se rough idle problem passinglane DIY/Tech Help 3 01-12-2011 08:34 AM
420 sel wont start... Help please Topper DIY/Tech Help 7 02-12-2010 04:27 PM
Car Wont Start any Help out there? Daheee Mercedes-Benz Sedans/Wagons 8 05-30-2006 11:24 PM
1985 300td wont shut off braden Diesel Discussion 1 09-21-2005 12:35 PM
car wont start spitfire Mercedes-Benz Sedans/Wagons 1 06-27-2004 08:30 PM

Powered by vBadvanced CMPS v3.2.2

All times are GMT -6. The time now is 01:24 AM.



Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Garage Plus vBulletin Plugins by Drive Thru Online, Inc.
© AutoGuide