Benz Forum banner

21 - 24 of 24 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #21
I know that I splice the connectors correctly because I did them wire by wire and I orientated the new connectors just like the old ones were. I was thinking it maybe a computer problem. Can i reset the computer or do I need to take it to the shop?
 

·
Registered
Joined
·
16 Posts
Discussion Starter #24
So I finally gotten around to taking my car to the shop and they told me the codes they pulled suggested that I replace both ABC Valves. I politely decline and get the car back to my house. I pulled the block again and found that one of the spring on the check valve fell off and was sitting in the block. I reclean the block and reinstalled it. The rodeo effect went away, but right front still low. The shop told me that all electrical were good, I am going to pull valve again and replace o rings with kit from harbor freight. The I rings I used were from SL55 manual I found on line cross section were thinner the what I took off. I will post result upon completion.
 
21 - 24 of 24 Posts
Top