Benz Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I am the owner of a 1984 300SD with nearly 300,000 miles on the original engine and transmission. Lately, the turnsignals have been exhibiting erratic behavior. Sometomes they work just fine, other times they either don't work at all or they just blink erratically. Any suggestions as to what may be the root cause of this problem are greatly appreciated.

Thanks in advance,

bobcat Bob
 

·
Registered
Joined
·
5 Posts
Check the fuses, not only for being blown, but for corrosion at the tips (clean then with sandpaper or pencil eraser). The sigs also go through the hazard switch (so it can take them over when activated), which may be bad. The sig 'clicker' relay is also a possibility.
 
1 - 4 of 4 Posts
Top